Skylark Tiny OSD RSSI Calibration
Only Percentage mode need the process
1. Make sure the RC receiver RSSI is connected to the OSD board.
2. Use the Skylark USB Cable connect your computer and the GPS port of the Tiny OSD board
3. Remote Control power on
4. RC receiver power on
5. Run Configuration Software
6. Click OSD->Calibrate
7. Click "Start" button
8. Remote Control power off
9. Click "Stop" button
10. Remote Control power on
Only Percentage mode need the process
1. Make sure the RC receiver RSSI is connected to the OSD board.
2. Use the Skylark USB Cable connect your computer and the GPS port of the Tiny OSD board
3. Remote Control power on
4. RC receiver power on
5. Run Configuration Software
6. Click OSD->Calibrate
7. Click "Start" button
8. Remote Control power off
9. Click "Stop" button
10. Remote Control power on
